Fernanda Regina Voltarelli

Summary

Publications

  1. ncbi request reprint Effect of different light-curing devices and aging procedures on composite knoop microhardness
    Fernanda Regina Voltarelli
    Piracicaba Dental School, University of Campinas UNICAMP, Piracicaba, SP, Brazil
    Braz Oral Res 23:473-9. 2009
  2. ncbi request reprint Effect of chemical degradation followed by toothbrushing on the surface roughness of restorative composites
    Fernanda Regina Voltarelli
    Piracicaba Dental School, State University of Campinas, Brazil
    J Appl Oral Sci 18:585-90. 2010
  3. ncbi request reprint Effectiveness of resin composite polymerization when cured at different depths and with different curing lights
    Fernanda Regina Voltarelli
    Department of Restorative Dentistry, Piracicaba School of Dentistry, Areiao, Piracicaba, SP, Brazil
    Gen Dent 57:314-9; quiz 320-1. 2009

Detail Information

Publications3

  1. ncbi request reprint Effect of different light-curing devices and aging procedures on composite knoop microhardness
    Fernanda Regina Voltarelli
    Piracicaba Dental School, University of Campinas UNICAMP, Piracicaba, SP, Brazil
    Braz Oral Res 23:473-9. 2009
    ..From all light-curing units, PAC may have rendered composites of reduced quality and the storage aging procedures were the most harmful to the polymer hardness...
  2. ncbi request reprint Effect of chemical degradation followed by toothbrushing on the surface roughness of restorative composites
    Fernanda Regina Voltarelli
    Piracicaba Dental School, State University of Campinas, Brazil
    J Appl Oral Sci 18:585-90. 2010
    ..Material and..
  3. ncbi request reprint Effectiveness of resin composite polymerization when cured at different depths and with different curing lights
    Fernanda Regina Voltarelli
    Department of Restorative Dentistry, Piracicaba School of Dentistry, Areiao, Piracicaba, SP, Brazil
    Gen Dent 57:314-9; quiz 320-1. 2009
    ..The microhardness was always higher on the top surface than on the bottom surface. No photocuring unit was able to properly polymerize the bottom surface as completely as the top surface...