Nicholas E Bishop

Summary

Affiliation: Hamburg University of Technology
Country: Germany

Publications

  1. doi request reprint The influence of bone damage on press-fit mechanics
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, 21073 Hamburg, Germany Electronic address
    J Biomech 47:1472-8. 2014
  2. doi request reprint Wear patterns of taper connections in retrieved large diameter metal-on-metal bearings
    Nicholas Bishop
    Instistute of Biomechanics, TUHH Hamburg University of Technology, Denickestrasse 15, 21073, Hamburg, Germany
    J Orthop Res 31:1116-22. 2013
  3. doi request reprint High friction moments in large hard-on-hard hip replacement bearings in conditions of poor lubrication
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, D 21073 Hamburg, Germany
    J Orthop Res 31:807-13. 2013
  4. doi request reprint Biomechanics of short hip endoprostheses--the risk of bone failure increases with decreasing implant size
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, Hamburg, Germany
    Clin Biomech (Bristol, Avon) 25:666-74. 2010
  5. ncbi request reprint The condition of the cement mantle in femoral hip prosthesis implantations--a post mortem retrieval study
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Hamburg, Germany
    Hip Int 19:87-95. 2009
  6. doi request reprint Friction moments of large metal-on-metal hip joint bearings and other modern designs
    N E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Hamburg, Germany
    Med Eng Phys 30:1057-64. 2008
  7. doi request reprint Influence of time in-situ and implant type on fixation strength of cemented tibial trays - a post mortem retrieval analysis
    Anne Gebert de Uhlenbrock
    TUHH Hamburg University of Technology, Germany
    Clin Biomech (Bristol, Avon) 27:929-35. 2012
  8. doi request reprint Estimation of shear load sharing in moderately degenerated human lumbar spine
    Daniel M Skrzypiec
    Institute of Medical and Biological Engineering, University of Leeds, Leeds, UK Institute of Biomechanics, TUHH Hamburg University of Technology, Hamburg, Germany
    J Biomech 46:651-7. 2013
  9. doi request reprint Shear strength of the human lumbar spine
    Daniel M Skrzypiec
    Institute of Biomechanics, TUHH Hamburg University of Technology, Hamburg, Germany
    Clin Biomech (Bristol, Avon) 27:646-51. 2012
  10. doi request reprint The influence of stem design on critical squeaking friction with ceramic bearings
    Na Fan
    Tribology Research Institute, Southwest Jiaotong University, Chengdu, 610031, China
    J Orthop Res 31:1627-32. 2013

Collaborators

Detail Information

Publications12

  1. doi request reprint The influence of bone damage on press-fit mechanics
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, 21073 Hamburg, Germany Electronic address
    J Biomech 47:1472-8. 2014
    ....
  2. doi request reprint Wear patterns of taper connections in retrieved large diameter metal-on-metal bearings
    Nicholas Bishop
    Instistute of Biomechanics, TUHH Hamburg University of Technology, Denickestrasse 15, 21073, Hamburg, Germany
    J Orthop Res 31:1116-22. 2013
    ..In contrast, samples with "axisymmetric" radial wear and a threaded imprint suggested that corrosion led to head subsidence onto the stem taper with gradual rotation...
  3. doi request reprint High friction moments in large hard-on-hard hip replacement bearings in conditions of poor lubrication
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, D 21073 Hamburg, Germany
    J Orthop Res 31:807-13. 2013
    ....
  4. doi request reprint Biomechanics of short hip endoprostheses--the risk of bone failure increases with decreasing implant size
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Denickestrasse 15, Hamburg, Germany
    Clin Biomech (Bristol, Avon) 25:666-74. 2010
    ..However, it is proposed here that shortening femoral endoprostheses can increase the risk of periprosthestic fracture...
  5. ncbi request reprint The condition of the cement mantle in femoral hip prosthesis implantations--a post mortem retrieval study
    Nicholas E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Hamburg, Germany
    Hip Int 19:87-95. 2009
    ..The frequency of almost all defects could be further reduced by careful implantation technique, providing the increased service life necessary for the ever younger, more physically demanding, patient population...
  6. doi request reprint Friction moments of large metal-on-metal hip joint bearings and other modern designs
    N E Bishop
    Biomechanics Section, TUHH Hamburg University of Technology, Hamburg, Germany
    Med Eng Phys 30:1057-64. 2008
    ..Swing phase load and a rest period between load cycles had little effect. The moment magnitudes are within the turn-out capacity measured for press-fit cups and might become critical with higher joint loads...
  7. doi request reprint Influence of time in-situ and implant type on fixation strength of cemented tibial trays - a post mortem retrieval analysis
    Anne Gebert de Uhlenbrock
    TUHH Hamburg University of Technology, Germany
    Clin Biomech (Bristol, Avon) 27:929-35. 2012
    ..Loosening of the tibial tray is cited as the most common cause of failure in total knee arthroplasty but the mechanism remains unclear. Post mortem specimens provide a unique opportunity to investigate the clinical condition...
  8. doi request reprint Estimation of shear load sharing in moderately degenerated human lumbar spine
    Daniel M Skrzypiec
    Institute of Medical and Biological Engineering, University of Leeds, Leeds, UK Institute of Biomechanics, TUHH Hamburg University of Technology, Hamburg, Germany
    J Biomech 46:651-7. 2013
    ..The apophyseal joints make a substantial contribution (65-55%) to anterior shear load-bearing over the initial 2mm of shear displacement but this decreases with increasing shear displacement...
  9. doi request reprint Shear strength of the human lumbar spine
    Daniel M Skrzypiec
    Institute of Biomechanics, TUHH Hamburg University of Technology, Hamburg, Germany
    Clin Biomech (Bristol, Avon) 27:646-51. 2012
    ..Shear loading is recognised as a risk factor for lower back pain. Previous studies of shear loading have either not addressed the influence of age, bone mineral density, axial height loss due to creep or were performed on animal specimens...
  10. doi request reprint The influence of stem design on critical squeaking friction with ceramic bearings
    Na Fan
    Tribology Research Institute, Southwest Jiaotong University, Chengdu, 610031, China
    J Orthop Res 31:1627-32. 2013
    ..The results suggest that shorter or heavier stems might limit the possibility of squeaking as lubrication deteriorates. The method developed can be used to investigate the influence of design parameters on squeaking probability...
  11. doi request reprint Influence of assembly procedure and material combination on the strength of the taper connection at the head-neck junction of modular hip endoprostheses
    Annelie Rehmer
    TUHH, Hamburg University of Technology, Biomechanics Section, Hamburg, Germany
    Clin Biomech (Bristol, Avon) 27:77-83. 2012
    ..The purpose of this study was to assess the influence of assembly force, assembly tool and number of hammer strokes on the taper junction strength of various material combinations...
  12. doi request reprint The effect of nucleotomy on facet joint loading - a porcine in vitro study
    Miklós F Ivicsics
    Institute of Biomechanics, TUHH Hamburg University of Technology, Hamburg, Germany Electronic address
    Clin Biomech (Bristol, Avon) 28:853-9. 2013
    ..In this study load bearing of the facet joints was compared between natural and nucleotomised spinal segments...